Products

Sliding Friction Measurement GMG Accessories Good preparation with suitable accessories Standardized test equipment is used for sliding friction measurement in accordance with current standards and specifications (EN 16165, EN 13893, ANSI NFSI B101.3, and DIN 51131). The surfaces of the sliders must be ground flat before measurement. They are then clean and dust-free and have [...]

Sliding Friction Tester GMG-200 Floor coverings must be slip-resistant. The mobile GMG 200 measures the coefficient of sliding friction of floor coverings according to the applied standards and specifications. This product is both easy to use and ideal for assessing slip hazards for pedestrians on-site. Features Mobile measuring device with battery operation Robust design Plain [...]

M-Bus Master M-BUSMASTER S The ADICOS M-BUSMASTER S is an interface between the ADICOS special fire detection system and the service PC. The communication interface for up to 20 ADICOS detectors is the economical, smaller and mobile version compared to the ADICOS BUSMASTER XF. The PC connection is based on a USB or Ethernet interface [...]

Branching and Connection Box for ATEX Zone 22 and 2 AAB-X22/X2 ADICOS-AAB-X22/X2 branching and connection boxes serve as wiring aids for special fire detectors within potentially explosive areas of ATEX zone 22 and 2. The industrial-grade surface-mounted junction boxes are equipped with an internally wired printed circuit board, which enables the electrical connection of ADICOS [...]

Branching and Connection Box AAB-XL ADICOS AAB-XL branching and connection boxes serve as wiring aids for ADICOS detectors under difficult conditions with up to seven cable glands. AAB-XL are extra large, high-quality surface-mounted junction boxes with internally pre-connected double-pole terminals, which enable the electrical connection of ADICOS detectors of all models to the special fire [...]

Force Measurement Device CBSF-Basic Hand-held measurement device used to evaluate transient and quasi-static forces and pressures on collaborating robots The CBSF-Basic is a force measurement device which, in combination with the CoboSafe-Scan pressure measurement set, represents a simplified measuring method. A measurement device with only one spring constant is used to determine the existing collision [...]

CBSF-XS Force Measurement Device for Grippers and in Confined Gaps The CBSF-XS force gauge is part of the CoboSafe family and is designed for cases where only confined gaps are available for measurement. This applies, for example, to determining the forces of grippers when used in human-robot collaboration (HRC). The measurement device's extremely small dimensions [...]

Force Measurement Device CBSF The CoboSafe CBSF force gauges accurately check the permissible load thresholds for workplaces with human-robot collaboration (HRC). The CBSF series consists of nine individual force gauges, each with a different spring constant between 10 N/mm and 150 N/mm. The modular principle enables institutes, manufacturers, system integrators, and operators to compile fitting [...]

ADICOS System Software The ADICOS system software enables convenient, computer-supported visualization of all measurement data and states of the ADICOS detectors. Fault and alarm messages are clearly displayed and their chronological sequence is documented. The ADICOS system software displays all information about the status of the entire system in an overview. Optionally, graphics can be [...]

Power Supply NT V40-A3 The ADICOS NT V40-A3 power supply unit guarantees the optimum power supply for your fire alarm system. In contrast to conventional fire detectors, the special fire detectors from the ADICOS range have a higher power consumption. Therefore, the detectors can also be supplied with 40V in order to reduce the power [...]